AEM’s external Peak & Hold Injector Driver module allows ECUÂ’s that have a saturated injector drive circuit to trigger low impedance injectors with a true 4/1 Peak & Hold injector drive circuit.
AEM’s Peak & Hold Injector Driver contains 10 independent injector drive channels. Each channel supplies full battery voltage to a fuel injector for rapid current rise; in order to produce positive injector opening. When load current reaches 4.1A (amps); the injector driver reduces the load current to 1.1A and operates as a constant current source. This condition holds the injector open; and reduces system power dissipation. If the current fails to reach 4.1A within 5mS; the driver module automatically reduces the load current to 1.1A.
Installation is straightforward. Users simply hook the injector trigger wires from an ECU to the module; and then hook the output wires from the module to your injectors. Any number of channels can be used from one to 10.
For high-output engines that have exceeded the capacity of high-impedance injectors Includes 10 independent injector drive channels for any engine up to V10 Complete wiring system included Operating Voltage: 8-18 volts; negative ground RPM Capability: Unlimited Injector Triggers: 10 Trigger Waveform: Output is activated when input trigger is grounded Trigger Impedance: 220 Ohm input impedance; pulled to 12V (60 mA draw) Injector Outputs: 10 Output Current High: 4.15A Peak; Typical Output Current Low: 1.15A Sustain; Typical Peak Current Timeout: 5mS Size: 5.5"L x 4.6"W x 1.4"H Weight: 2.7 Lbs Over Temperature Shutdown: 115C (Nominal) Please note:All Prices are subject to change due to exchange rates & price alterations from suppliers.For more information please click
here
