Search results for 'brake it'

COMPETITION CLUTCH
Stage 4 Sprung - Strip Series 1620 Clutch Kit

This assembly; available with a double spring; six rivet carriage is good for ease of gear transition with higher horsepower. This disc complimented by a performance pressure plate provides up to 250% increase in torque capacity. 300 mile break-in recommended with this set-up.

The 1620 Series kit includes a performance pressure plate; a six puck high torque sprung disc with Ceramic buttons; all applicable bearings; and the appropriate alignment tool.

Learn More

Built for performance and show. the Typhoon® Air Intake System is a free-flowing mandrel-bent aluminum tube induction system designed to fit many sport compact performance vehicles.  Each kit is proven on a rear-wheel dynamometer to increase horsepower and torque. Typhoon intakes come in one of three designs; cold air intakes (CA). short ram intakes (SR). or complete cold air (CCA) intakes which can be configured as either a cold air intake or a short ram intake.  They come with an oversized High-Flow conical air filter designed to provide increased surface area and dust capacity. This extra surface area provides even more airflow at lower restriction than a standard K&N O/E replacement filter that is limited to the size of the factory air box. The oversize air filter also captures more dirt increasing the service life before a cleaning is required (up to 100.000 miles).  Some Typhoon Air Intakes are not legal for use in California and other states adopting California emission standards while others are CARB exempt and 50 state legal.

Designed for increased performance for your sport compacts. utilizing the finest quality components Guaranteed to Provide more horsepower and increased acceleration Available in high-quality finishes Includes K&N High-Flow. Washable/Reusable Air Filter Some applications available in cold-air versions Easy to Install Million Mile Limited Warranty Street legal in most states (some not street legal in CA - Check part number or vehicle listing for specific CARB status)

 

Typhoon Cold Air Intake Kit
Engine :-
Aspiration :- T
Vehicle Engine Options :- EJ257
Vehicle Interior Options :- H4 Aspiration: T
Vehicle Exterior Options :- Fuel: FI-GAS
Cylinder Type :-
Vehicle Options :- ColorWrinkle Red Learn More

For: Subaru Impreza RS YR: 1996-1997 Cyl: 4 App: 1.8L / 2.2L
The FX200 System uses the Power Plus I Pressure Plate and a Steel Backed Kevlar disc. This clutch is designed for the street enthusiast or weekend racer. The FX200 offers similar torque rating and holding capacity as the FX100, however, its life expectancy is increased with the Kevlar disc. Our Kevlar friction material is non-abrasive and doesn't score the mating surfaces. It features only slightly increased pedal pressure, significantly longer life than stock, and normal clutch feel during engagement and disengagement for the smoothest operation of any stage we offer. Minimum 500 Required break in miles. Please see The Technical guide for more details Learn More

For: Subaru Impreza RS YR: 1995-1995 Cyl: 4 App: 1.8L 2WD
The FX400 System uses the Power Plus I Pressure Plate with a custom, extremely durable, Sprung Ceramic disc. This is the ultimate extreme duty street and/or road/drag racing system. It is available in a 4,6 or 8 wing (paddle) configuration, with the 4-wing being the more aggressive setup and 8-wing being the less aggressive (please specify which type you prefer). The sprung hub design allows for moderate dampening in high-torque applications, rendering it much more street friendly than solid or rigid designs. This disc is designed for outstanding holding capacity, and rapid heat dissipation. The FX400 ceramic paddle design creates a quick and rapid engagement as well as clutch chatter that may not be ideal for street driven vehicles.  Learn More

The Cosworth ECPro is a higher performance solution engine management. Engineered in conjunction with Pectel Control Systems; Cosworth ECPro features an compatible harness connector a full base calibration allowing to go straight to dyno without workload of full and vehicle configuration.
The Cosworth ECPro is perfect demanding applications such as track day; rally motorsport and is housed in a machined from solid aluminum case with professional motorsport specification electronics. />Features
Designed full harness system integration Plug Perform. Base calibration supplied to a stock engine. There is no need replacement of wiring harness or sensors. Makes of dash diff controller
56Mhz processor. Higher performance timing accuracy control Ethernet comms Fast data offload high quality data viewing on PC
Internal logging memory. configured logging channel configuration at optimum rates performance analysis by your dealer. User define specific logging configurations. on board internal memory up to 2;000Hz of logging bandwidth is standard.
Knock monitoring Control. Advanced knock processing chip offers industry leading advanced knock signal filtration signal processing. MIL lamp indication of Detonation levels (witser defined levels based on and Boost).
Calibration select. (e.g. Fuel save; Test; Race) of OEM SI Drive switch selection of 3 alternate calibrations (calibration selectable boost; fuelling; ignition;rev limit; setting; VCAM target; Fly-By-Wire pedal mapping; overrun fuelling cut-off individually selectable Intelligent; Sports; Sports-Sharp).
Pectel (Anti System) switch (cruise control button) used ALS mode select.
Analog Inputs external sensors. Additional pressure transducers; temperature sensors; digital inputs be wired into EC for logging additional engine parameters and/or additional control strategies. number of analog inputs depends on specific model.
Closed Loop Boost Control. Full closed loop or open loop boost control PID parameters solenoid duty cycle map. Closed loop boost levels also selectable calibration select (see above).
Standard Motorsport Design. Machined billet aluminum case professional motorsports specification electronics.
OEM Narrow Band Supported be disabled by user.
External Wideband Supported. Compatible with wideband units with 0-5v analog output.
Internal Wideband Supported. kit Requires Cosworth by Pectel sensor; requires 3 extra populations 2 relocating. blank pins on harness populating.
Variable CAM. Pre-configured full quad camshaft support />External Comms Support. Optional Motorsport dash center differential controller.
Designed Racing OBDII Motorsport us Learn More

For: Subaru Impreza RS YR: 1994-1995 Cyl: 4 App: 1.8L 4WD
The FX400 System uses the Power Plus I Pressure Plate with a custom, extremely durable, Sprung Ceramic disc. This is the ultimate extreme duty street and/or road/drag racing system. It is available in a 4,6 or 8 wing (paddle) configuration, with the 4-wing being the more aggressive setup and 8-wing being the less aggressive (please specify which type you prefer). The sprung hub design allows for moderate dampening in high-torque applications, rendering it much more street friendly than solid or rigid designs. This disc is designed for outstanding holding capacity, and rapid heat dissipation. The FX400 ceramic paddle design creates a quick and rapid engagement as well as clutch chatter that may not be ideal for street driven vehicles.  Learn More

The piston is of most important components within engine. It be subjected to directional change up to times every second must withstand acceleration forces of 8500gs. Cosworth high performance forged pistons designed engineered to withstand this type of punishment still perform. Cosworth's pistons manufactured using same methods as Formula pistons include features such anti scuff skirt coating; ultra-strong pins; polished and patented antidetonation bands. Additionally; each application uses a unique forging to minimize weight ensure strongest possible piston design.
Key Features
Unique forgings each application
Xylan anti scuff skirt coating
Polished tops (reduces carbon build up relieves stress)
Manufactured from proprietary alloy (CosAl 010)
Ultra strong pin
Patented anti-detonation bands Learn More

For: Subaru Impreza RS YR: 1993-1993 Cyl: 4 App: 1.8L 4WD
The versatile FX500 System uses either the Power Plus I or Power Plus II Pressure Plate along with a solid center 4,6 or 8 wing (paddle) Ceramic Button disc. The FX500 disc is designed for outstanding holding capacity and rapid heat dissipation. The FX500 ceramic paddle design creates a quick and rapid engagement as well as clutch chatter that is not recommended for the street. Learn More

The piston is of most important components within engine. It be subjected to directional change up to times every second must withstand acceleration forces of 8500gs. Cosworth high performance forged pistons designed engineered to withstand this type of punishment still perform. Cosworth's pistons manufactured using same methods as Formula pistons include features such anti scuff skirt coating; ultra-strong pins; polished and patented antidetonation bands. Additionally; each application uses a unique forging to minimize weight ensure strongest possible piston design.
Key Features
Unique forgings each application
Xylan anti scuff skirt coating
Polished tops (reduces carbon build up relieves stress)
Manufactured from proprietary alloy (CosAl 010)
Ultra strong pin
Patented anti-detonation bands Learn More